Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Layzzzee8

Pages: [1]
1
Have you made sure you turned up the PCM volume level?  By default its set to zero in these builds.  That could cause no UI sounds (it would also cause any PCM playback, like mp3, etc) to not be heard.   Press 0 and then + on your keyb/remote to turn it up.

If that doesn't do the trick, I am not sure.  Does your receiver register that it's getting a PCM stream when you are sitting in the GUI without any movie playing?


I turned up the PCM volume like you advised but it won't go any higher than 1db.   If I put my ear right up to the speaker I can hear the navigation sounds.  Any way to make them louder?

2
if you are getting no interface sounds at all that would indicate a problem.

But, if you only get no interface sounds while playing DTS audio, I think that is to be expected since the digital stream is being passed directly to your amp and nothing can be added.  Same problem with DTS and AC3 movies if you try to use TTS or otherwise generate sounds from your PC.  The amp will be locked onto the DTS stream and nothing else will play.

I'm no expert on this, it is just based on my recent experience with my Onkyo 5.1 receiver and XBMC.

On all other installations of XBMC navigation sounds work fine.  On this one, I get no navigation sounds whether I am playing a movie or not.  DTS-MA and all other audio formats play fine during movie playback.  Currently using a Radeon 5570 with HDMI to my Denon AVR-991.

3
Hello,

I compiled today new build XBMC 11 with audio HD, link is the same:

http://dl.dropbox.com/u/25170804/xbmc2.zip

Recent Master XBMC + AE (audio engine) with new corrections...

Enjoy...

Wanilton

For some reason I get no navigation sounds.  Everything else seems to work like a charm.  Loving the DTS-MA tracks!  Any idea how to get navigation sounds back?   

Pages: [1]