Messages

1

VoxCommando Basics and Core Features / Re: Vox Crashes When opening Command Edit Tree

« on: October 27, 2014, 01:06:55 AM »

My objective was to build voxcommando’s command tree to the fullest ongoing potential within my reach, especially to voice operate everything I already had in place and also what I can add to my home at a reasonable cost since I am so amazed with the programs potential.
Almost all of the commands I build on my own I have in just about 8 groups, together with 17 more from XBMC, 17 from JRiver (which I need for the photo feature mainly), 9 Vera, 7 Hue, 10, Vox standard basic groups and about 7 from the Vox forum link exchange etc. that’s my 75.  I think it’s pretty easy to build up the numbers.  There are about 8 other rarely used groups I eliminated so that the tree edit window would not crash.  I intend to consolidate these groups in to much smaller numbers next so that I can continue adding as I discover new capabilities for the program.
I did install version 2.1.0.7 based on you last post and added back 5 of the groups I removed from the tree but no luck the program crashed as before.
I don’t think it’s really an issue though since for example XBMC, JRiver, and Hue can be consolidated into just 3 groups if I need to.
Just that you know, I have an enormous love for Voxcommando and I thank you and the team on the forum for the continued ongoing improvements and enhancements.
Thanks again.

2

VoxCommando Basics and Core Features / Re: Vox Crashes When opening Command Edit Tree

« on: October 25, 2014, 02:13:20 AM »

Thanks very much James for least letting me know that you understand and acknowledge the problem, you are correct with all that you said.  It drove me nuts for a couple of days until I realized what was causing the program to crash.  It’s also good to see that there is hope for a fix.

3

VoxCommando Basics and Core Features / Re: Vox Crashes When opening Command Edit Tree

« on: October 23, 2014, 11:01:52 PM »

Hi nime5ter, thanks so much for responding.  The best working configuration I have that works has 75 groups. I removed 8 groups that I rarely used from my original configuration and added the 7 groups from the Hue setup and that works.
However if the number of groups is in fact a limitation in Vox then I am stuck here and the only way I can add anything more to the command tree is to start combining groups which can become very difficult and confusing when I need to trouble a problem.  Any suggestions?

4

VoxCommando Basics and Core Features / Vox Crashes When opening Command Edit Tree

« on: October 23, 2014, 07:22:22 PM »

I am having a issue when opening the command tree window, it flashes the window frame only and drops down into the windows start bar as a Vox icon.  This started after incorporating the preset Hue commands that are built in to Vox ver 2.1.0.5b.  My original command tree works great and the Hue commands work great on a separate installation.  The problem only exists when they are combined.
I have determined that the problem can be resolved by reducing the number of commands in my tree. Am I correct? Is this problem the reaction Vox will give if the commands tree is too large (but it is not that large). I am running Vox 2.1.0.5b on windows 7 with an i3 processor and 4 GB ram.
Any advice will be appreciated.