VoxCommando

Help and Support (Using VoxCommando) => Other Plugins => Topic started by: NetZero on September 13, 2016, 10:47:00 PM

Title: iTach IP2IR coding?
Post by: NetZero on September 13, 2016, 10:47:00 PM

what plugin is required to send commands to iTach?

This is the code I want to send to power on my DirectTV box!

sendir,1:1,1,39000,1,1,232,46,46,46,23,23,46,23,23,23,23,23,23,46,46,46,46,46,23,1155,116,46,46,46,23,23,46,23,23,23,23,23,23,46,46,46,46,46,23,1155,116,46,46,46,23,23,46,23,23,23,23,23,23,46,46,46,46,46,23,46

Title: Re: iTach IP2IR coding?
Post by: Kalle on September 14, 2016, 03:58:19 AM

Hi NetZero,


there are serval methodes to send GC iTach codes with VoxCommando.
One of them is to use the TCP-plugin - here is the right place for you: http://voxcommando.com/forum/index.php?topic=1173.0


You can also use the search function in the upper right corner and search for - send iTach - and you will get a lot of matches.


I hope this will help you

Title: Re: iTach IP2IR coding?
Post by: NetZero on September 14, 2016, 02:21:27 PM

Thanks!!! I got it working. I had to read through the xml file to find the commands I needed.

Title: Re: iTach IP2IR coding?
Post by: nime5ter on September 14, 2016, 04:15:13 PM

http://voxcommando.com/mediawiki/index.php?title=XML_on_the_forum

Title: Re: iTach IP2IR coding?
Post by: NetZero on September 15, 2016, 02:08:32 PM

The problem was that I was using the wrong output on the iTach and the code I got from a web search was wrong. I have a GC IR learner that I used to capture the correct code and sent it to the correct port/output on the iTach. I was reading the port/output numbers wrong on the unit itself. I initially was plugged into output 3 instead of 1.